Pass the points to Vector 2Pt This component will out put a vector from the points which has the length of the line.Place End Points component which takes in Cure and extracts the Start point and End point.Need to find the direction of the selected line (2D Curve) to decide the balcony orientation. Right click on the panel component to rename it as Storey Height for the ease of identification. ![]() Panel component is used because there will not be a drastic change in storey height and this will also be used in the later part of the solution. Once done the vector will have the length as 3000 mm long and the direction as Z. Use the storey height (3000 mm) as the factor. Unit Z component takes in an input Factor which multiplies the unit vector by the given input.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |